By the time you see a stain or hear dripping, a burst pipe has often already been running for a while inside the wall.
We open the wall cavity carefully, only as far as moisture readings say is necessary, rather than tearing out an entire wall.
We'll walk you through shutoff steps over the phone if you call before we arrive.
Our Clovis, NM crews trace pressure loss to identify the failure point before opening drywall.
Drywall and insulation come out only where moisture readings confirm saturation, not the entire wall.
We coordinate directly with a licensed plumber for the actual pipe repair once our mitigation work is done.
A burst pipe call has a specific sequence — find the source, stop it, open only what's necessary, and coordinate repair — here's how our Clovis, NM crews run it.
We locate and confirm the shutoff valve is closed the moment the crew arrives.
Diagnostics narrow down the exact wall section affected.
We extract from within the cavity itself, not just the surface that's visible.
Saturated insulation is removed and replaced, while drywall is cut only at the confirmed wet line.
Drying continues until wall cavity moisture readings hit dry standard.
We coordinate scheduling with a licensed plumber for the pipe repair itself.
A quick call helps us prioritize the dispatch appropriately.
Our nearest crew arrives ready to confirm shutoff and begin diagnostics.
A pressure and moisture assessment comes before any wall opening.
We verify wall cavity moisture readings hit dry standard and confirm plumber repair is scheduled before closing the file.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
We can confirm which you're dealing with during the initial assessment.
No, we remove drywall only at the confirmed wet line based on moisture readings.
Pipe repair is handled by a licensed plumber we coordinate with, while we manage extraction and drying.
If you can safely reach it, shut off the water at the main or local valve to stop the flow.
Most burst pipe jobs dry out within about a week, similar to other structural drying timelines.
Clovis sits within our core burst pipe response zone.
Call now and we'll help you locate the shutoff valve over the phone if needed.
Call +1-844-578-1604